How To Pick A Master Lock At School

Building a cable SCART - SVHS


Materials Required: A

SCART with all the pins, taking a four-pin MINI DIN MALE placed as the diagram below, two female RCA jacks (preferably gold), four-wire cable plus the mass for SVHS (in a single strand) of cable with two conductors and two masses for the audio (in two separate wires, each with a mass and a cable to the signal).


how:

Solder the two wires (SVHS and audio) to the scart pins according to the diagram below, of course a note of the thread color and number of the corresponding pin and then solder to the right of the pin mini din plug the SVHS and two RCA audio. The mass that surrounds the SVHS cable soldered to the metal housing of the scart, or make sure it is good contact between the casing and inserting the plastic, this is very important because doing so will protect the carcass SVHS signals from external interference, the Board also did not longer than three or four meters at the maximum not to weaken the segnle SVHS, audio, there is no problem because the sound card taken from (the output that goes to the speakers) which is amplified (about two watts) of course you use the external masses which enclose the audio cable to the audio ground.

To make good welds I suggest you tin the wires before soldering to the pins of the sockets, and use of cavi di qualità.